<address id="5dhjf"></address>

            <address id="5dhjf"></address>

                    <address id="5dhjf"></address>
                    產品展示
                    PRODUCT DISPLAY
                    產品展示您現在的位置: 首頁 > 產品展示 > 臺灣儀鼎PICOTEST > PICOTEST測試訊號轉換器 > INJB03PICOTEST儀鼎儀器專業測試訊號轉換器

                    PICOTEST儀鼎儀器專業測試訊號轉換器

                    更新時間:2017-08-09
                    瀏覽次數:1171
                    簡要描述:

                    PICOTEST儀鼎儀器專業測試訊號轉換器專業代理銷售現貨供應INJB01,INJB02,INGB03,J2100A.J2101A,J2102A,J2110A,J2111A,J2112A,J2120A,J2130A,J2140A,J2160A,J2180A,J2180A-20,J2190A

                    在線咨詢

                    PICOTEST儀鼎儀器專業測試訊號轉換器

                    INJB01測試訊號轉換器

                    What's included:

                    J2100A Injection Transformer 1Hz - 5MHz
                    J2101A Injection Transformer 10Hz - 45MHz
                    J2110A Solid State Injector
                    J2120A Line Injector
                    J2130A DC Bias Injector
                    J2111A Current Injector 
                    J2170A High PSRR Power Adapter (Shipped Separay)
                    User manual

                    PICOTEST儀鼎儀器專業測試訊號轉換器

                    INJB02測試訊號轉換器

                    What's included:
                    J2110A Solid State Injector
                    J2111A Current Injector
                    J2120A Line Injector
                    J2130A DC Bias Injector
                    J2140A Attenuator 
                    J2170A High PSRR Power Adapter
                    User manual

                    INJB03測試訊號轉換器

                    What's included:
                    J2111A Current Injector
                    J2101A Injection Transformer 10Hz - 45MHz
                    J2120A Line Injector
                    J2140A Attenuator 
                    J2170A High PSRR Power Adapter
                    User manual

                    J2100A Injection Transformer 1Hz~5MHz 

                     
                     
                    J2100A測試訊號轉換器
                     
                     
                    iconLow band corner frequency 達1Hz,可支援 功率因數控制器(PFC)之穩定性測試
                    icon5MHz帶寬足以量測大多數電源和穩壓器
                    icon超高頻寬,可達23 Octave
                    icon優異精確的低失真表現
                    icon5Ω終端,對待測電路的影響降至zui小
                    icon包括衰減功能來確保小信號的測量正確性
                    icon詳細規格
                     
                    Product Information

                    The injection transformer is presently the prevalent method for connecting the network analyzer to the circuit being tested, and is primarily used for control loop stability measurements. The goal of the transformer is to inject a signal into the control loop being measured, without impacting the performance of the loop. In order to accomplish this to a reasonable degree, The transformer is isolated and therefore is capable of floating on a high voltage, such as a Power Factor Corrector (PFC), which is often close to 400VDC. Measuring voltages that exceed the voltage rating of the FRA inputs require attenuation probes.

                    The usable bandwidth of an injection transformer is generally significantly greater than the 3dB frequency limits. This is because the transformer itself is outside of the measurement, leading many to incorrectly believe that the transformer is a non-critical element.

                    The bandwidth of the transformer is strongly related to the terminating impedance. The most network analyzers provide a 50 Ohm oscillator source impedance. Assuming this impedance the optimal termination resistor is 5 Ohms. This significantly attenuates the injection signal, which is generally beneficial, as a common error in Bode measurements is using a signal which is too large, and therefore not a small signal measurement. An added benefit of this low value is that it can generally be left in circuit at all times, simplifying the connection to the network analyzer without appreciably impacting the output voltage of the circuit being tested.

                     
                    Detailed Specifications:
                     
                    Performance at -10dBm input level
                    CharacteristicRating
                    DCR 
                    Ratio1:1
                    Termination Impedance5 Ohms
                    Nominal 3dB Bandwidth1Hz ~ 5MHz
                    Isolation Voltage600V
                    Isolation Capacitance390pF@1KHz
                    DC Current10mA
                    Temperature Range0 ~ 50°C
                    Maximum Altitude6000 Ft

                     J2100A測試訊號轉換器

                    J2100A 1 hz - 5 mhz
                    J2101A  10 hz - 45 mhz
                    J2110A
                    J2120A
                    J2130A

                    J2140A

                    J2160A

                    J2180A

                    J2180A

                    J2190A

                     

                     

                    聯系方式
                    • 服務熱線:

                      4009023318

                      13913158248

                      15295666126

                    • 公司電話:

                      0512-66315386

                    • 公司傳真:

                      0512-66315383

                    在線客服
                    • 技術支持:
                    • 產品咨詢:

                    正大彩票
                    掃一掃訪問手機站掃一掃訪問手機站
                    訪問手機站